Idiomas disponibles
Idiomas disponibles
Use only accessory tools approved for a speed at least equal to the rated speed stated on the product.
1. Clean the clamping flange and the quick-release clamping nut.
2. Fit the clamping flange on to the drive spindle.
3. Make sure that the clamping flange is seated correctly.
4. Set the accessory tool on the clamping flange.
5. Press and hold down the spindle lock button.
6. Set the quick-release lock nut on the accessory tool.
7. Firmly tighten the quick-release lock nut.
8. Release the spindle lock button.
9. Switch the grinder on. → page 27
CAUTION
Risk of injury! Damaged grinding wheels can work loose.
▶ Protect the grinding wheels from blows, impacts and grease.
▶ Do not use vibrating grinding wheels.
10. Allow the grinder to run for at least one minute without load to ensure that the accessory tool is correctly
installed.
5.5
Removing the accessory tool
1. Press and hold down the spindle lock button.
2. Undo the quick-release lock nut.
3. Release the spindle lock button.
4. Remove the accessory tool.
5.6
Adjusting the guard
1. Set the grinder on the grinding wheel.
2. Use the height adjuster to adjust the height.
▶ Optimum height: approximately 1 mm clearance between sealing lips and surface.
3. If you are working along a corner, turn the segment opening of the guard to the desired position.
4. Be sure to close the segment opening when you finish working along the corner.
5.7
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
26
English
3
4
2359096
*2359096*
