Idiomas disponibles
Idiomas disponibles
32.
Locking pin
33.
Sawing shaft lock
34.
Flange screw
a.) Lock nut
b.) 90° stop bracket (not included in the scope of sup-
ply)
c.) 45° stop bracket (not included in the scope of sup-
ply)
d.) Allen key size 6
e.) Philips screw
f.)
Wrench size 13
g.) Philips screw (laser)
3. Scope of delivery
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• Drag, crosscut and mitre Saw
• 2 x Clamping device (19)
• 1 x Workpiece support (11 - 11a)
• Sawdust bag (21)
• Allen key 6 mm (d)
• 2 x carbon brush
• Operating manual
4. Intended use
The drag, crosscut and mitre saw is designed to cross-
cut wood and plastic respective of the machine's size.
The saw is not designed for cutting firewood.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufactur-
er will be liable for any damage or injuries of any kind
caused as a result of this.
26 | GB
The equipment is to be operated only with suitable
saw blades. It is prohibited to use any type of cut-
ting-off wheel.
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be in-
formed about the equipment's potential hazards. It
is also imperative to observe the accident prevention
regulations in force in your area. The same applies for
the general rules of health and safety at work.
The manufacturer will not be liable for any changes
made to the equipment nor for any damage resulting
from such changes.
Even when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk fac-
tors. The following hazards may arise in connection
with the machine's construction and design:
• Contact with the saw blade in the uncovered saw
zone.
• Reaching into the running saw blade (cut injuries).
• Kick-back of workpieces and parts of workpieces.
• Saw blade fracturing.
• Catapulting of faulty carbide tips from the saw
blade.
• Damage to hearing if ear-muffs are not used as
necessary.
• Harmful emissions of wood dust when used in
closed rooms.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the equipment is used
in commercial, trade or industrial businesses or for
equivalent purposes.
5. Safety information
General power tool safety warnings
m WARNING! Read all safety warnings, instruc-
tions, illustrations and specifications provided
with this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or se-
rious injury.
Save all warnings and instructions for future ref-
erence.
www.scheppach.com
