Storing; Scrapping; Instructions For The Dorrect; Electronic Equipment (In Italian Raee) - Butler KENDO.30LIGHT Manual De Instrucciones

7105-M002-0_B
D
Seite 43 von 106
KENDO.30LIGHT-KENDO.30LIGHTFI

16.0 STORING

If storing for long periods, disconnect the main power
supply and take measures to protect the machine from
dust build-up. Lubricate parts that could be damaged
from drying out. When putting the machine back into
operation replace the rubber pads and the mounting tool.

17.0 SCRAPPING

When the decision is taken not to make further use of
the machine, it is advisable to make it inoperative by
removing the connection pressure hoses.
The machine is to be considered as special waste and
should be dismantled into homogeneous parts.
Dispose of it in accordance with current legislation.
17.1 Instructions for the dorrect manage-
ment of waste from electric and

electronic equipment (in italian RAEE)

according to legislative decree 151/
05
• RAEE may not be disposed of as urban waste.
• These kinds of waste must be collected separately and
taken to dedicated collection and recycling centres,
according to OEM instructions and abiding by national
laws.
• The above symbol on the product means that anyone
wishing to dispose of the waste must follow the above-
mentioned instructions.
• Any incorrect management of the waste or its parts or
its abandonment outside dedicated areas could con-
taminate the environment, owing to the dangerous
substances contained in it, and cause damage to hu-
man health, flora and fauna.
• National laws provide for sanctions against those re-
sponsible for illegal disposal or abandonment of waste
from electric and electronic equipment.
Fig. 49
BEDIENUNGS- UND
WARTUNGSHANDBUCH

18.0 REGISTRATION PLATE DATA

The validity of the Conformity Declaration enclosed
to this manual is also extended to products and/or
devices the machine model object of the Conformity
Declaration can be equipped with.

19.0 LIST OF COMPONENTS

A list of individual components of the machine with re-
lated diagrams is provided below.
THE DIAGRAMS SERVE ONLY
FOR THE IDENTIFICATION OF
PARTS TO BE REPLACED.
THE REPLACEMENT MUST BE
CARRIED OUT PROFESSION-
ALLY QUALIFIED PERSONNEL.