Turn the appliance back on again by
pressing the
Press the start/stop button. The ironing
dummy inflates.
It is not necessary to wait for the preheating
time to finish. You can press Start/Stop
when you wish. The length of the ironing
time automatically adjusts in order to give a
good result depending on the amount of
time the appliance has been allowed to
preheat for. The same cycle may, therefore,
last different lengths of time.
If the adjustment cords have been
overadjusted, adapt the ironing dummy to
the size of the garment by gradually
loosening the cords.
Pull the side seams on the shirt firmly
downwards, Fig. 12.
Raise the sleeves and smoothen them out
in straight-lined motions from the shoulder
seam to the cuffs, Fig. 13.
Position any pleats on the shirt (on the
back, yoke and cuffs), Fig. 14.
Smoothen out any breast pockets or
pockets in other positions, Fig. 15.
The position of the programme selector
switch should not be changed during the
ironing process.
Changing the position of the programme
selector switch during the ironing process
does not alter the original programme
setting.
In order to fix the result of the ironing process,
the ironing dummy blows cold air for the last
minute of the ironing cycle. The "start / stop"
light flashes during this minute.
When the ironing process comes to an end, a
sound signal is emitted and the light indicating
the "start / stop" function goes out.
button.
Use
Pausing the ironing process
The ironing process can be paused to stop the
ironing process, e.g. to correct the width of the
ironing dummy. To do this:
Press "start/stop" while the ironing cycle is
under way.
The ironing process stops and the airing
motor turns itself off. The "start/stop"
indicator light flashes for 30 seconds. The
ironing programme can be started again at
any time during this period.
Adjust as desired.If you press Start/Stop
again during this period, the appliance
continues the cycle from where it left off.
If the 30-second time limit is exceeded, the
"start/stop" function light goes out: the
programme has finalised. It is necessary to
start a new ironing cycle.
If you change the position of the
programme selector switch while on
pause, the pause option is disabled and it
is necessary to reprogramme the
appliance. The previously-selected
programme is interrupted.
End of the ironing process
When the minute of cooling comes to an end,
a sound signal is emitted and the programme
finalises.
The ironing dummy slowly deflates.
Set the collar adjuster knob to vertical.
Open all the flaps on the button band
adjuster and on the collar support.
Open all of the flaps on the button band
adjuster and the collar support.
Release the cuff adjusters and pull them out
of the stretched shirtsleeves.
Leave the shirt to cool on a hanger to help
fix the results of the ironing process.
The next shirt can now be fitted onto the
appliance ready for the ironing process to
begin again.
27