WAGNER SUPER FINISH 23 PRO Manual De Instrucciones página 30

EN
SAFETY REGULATIONS
e) Maintain the power tool and insertion tools with
care. Check whether moving device parts are working
flawlessly and are not jamming, whether parts are
broken or damaged so that as to impair the function
of the power tool. Have damaged parts repaired before
using the power tool. Many accidents have their origin in
power tools that have been maintained badly.
f) Use the power tool, accessories, insert tools, etc. in
accordance with these instructions and in a fashion
specified for this special tool type. Take the working
conditions and the activity to be carried out into
consideration. The use of power tools for purposes other
than the intended ones can lead to dangerous situations.
g) Keep the handles and grip surfaces dry, clean and free
of oil and grease. Slippery handles and grip surfaces
hamper safe operation and control of the electric tool in
unforeseen situations.
5. Service
a) Only have your power tool repaired by a qualified
specialist and only use original spare parts. This
ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced
by the manufacturer or it's service agent or a
similarly qualified person in order to avoid a safety
hazard.
30
2
SAFETY REGULATIONS FOR
AIRLESS SPRAYING
All local safety regulations in force must be observed.
The following sources are just a sample of those containing
safety requirements for Airless spraying.
a) The European Standard „Spray equipment for coating ma- terials – safety regulations „ (EN 1953).
The following safety regulations are to be observed in order
to ensure safe handling of the Airless high-pressure spraying
unit.
2.1
FLASH POINT
Only spray coating materials with a flash point
of 21 °C or higher.
The flash point is the lowest temperature at
which vapors develop from the coating ma-
terial. These vapors are sufficient to form an
inflammable mixture over the air above the
coating material.
2.2
EXPLOSION PROTECTION
Do not use the unit in work places which are
covered by the explosion protection regula-
tions. The unit is not designed to be explo-
sion protected. Do not operate the device in
explosive areas (zone 0, 1 and 2). Explosive ar-
eas are, for example, places where paints are
stored and locations in direct proximity to the
object being sprayed. Keep the device at least
3 m from the object you are spraying.
2.3
DANGER OF EXPLOSION AND FIRE FROM
SOURCES OF IGNITION DURING SPRAYING
WORK
There must be no sources of ignition such as,
for example, open fires, lit cigarettes, cigars or
tobacco pipes, sparks, glowing wires, hot sur-
faces, etc. in the vicinity.
Super Finish 23 Pro