Idiomas disponibles
Idiomas disponibles
Adjustments
5.2.1 Extension of the gripper width
For optimum gripping of the stone layers, it is possible to
change the gripper width (of the main clamping)
Reason: Often the outer feather-steel-lamellas (Fig. 3)
overlaps outside of the stone layer during the gripping
process and thus complicate the direct positioning to an
already laid stone layer eventually.
For this purpose, in each case the two outer feather-
steel-lamellas are depending on each situation (at the
planum / facing bedding sand and both on the machine
side of the main clamping) by replacing the appropriate
accessories "feather-steel-lamellas" (Fig. 4).
C: Feather steel lamellas to extend the gripper length at
the main clamping (3401.0100)
D: Feather steel lamellas to reduce the gripper length at
the main clamping (3401.0016)
5.3
Adjustment of the main gripping
5.3.1 General
Adjustment of the main gripping on the device (machine side and laying side) according to the length of the
stone layer.
Remove the both angled chains (1) from the upper chain
suspension and lay them outward on the ground (Fig. 5).
51400035
Fig. 3
Fig. 4
1
Fig. 5
18 / 35
1
GB
