Operation; Adjustment Of The Gripping Range; Device Operation - probst VZ-I Instrucciones De Uso

Operation

5 Operation
5.1

Adjustment of the gripping range

•
The indicated gripping range of the device is adjustable by changing the socket pins.
•
Remove split pin (1) and pull socket pins (2) out.
•
Move gripping arms against each other, until the desired gripping is adjusted.
•
Insert socket pin (2) again and secure it with split pin (1).
•
The adjustment of the gripping range has to follow general symmetrical.
That means, it must be used in each case the same adjustable hole with both rectangular tubes.
Otherwise the device hangs diagonal.
Caution while adjusting of the gripping range. There is danger of injuring the hands!
Use safety gloves. →
5.2

Device operation

•
Connect the device with the suspension lug to the lifting device and move it to the required position,
•
or use the device as a TWO-MEN-DEVICE
•
Lower and position the device slowly on the gripping good (kerb stone).
•
When lifting the device the grippers cant with side surface of the gripping good and it can be lifted and
transported.
•
Avoid quick or jerky movements with the device, as the gripping good could fall down.
•
Move the device careful to the destination place and deposit device together with the gripping good on
the ground.
•
Release the device from the gripping good with the help of the two handles, when lifting the device.
53100140
1
2
Fig.2
14 / 18
Split pin
Socket pin
GB