Idiomas disponibles
Idiomas disponibles
Adjustments
5
Adjustments
Caution while adjustment work. There is danger of injuring the hands!
Use safety gloves! →
5.1
General
•
To reach the optimal laying performance with the hydraulic installation clamp, it hast o be properly adjusted to
the stone layers. Therefore observe the following issues and follow the adjusting instructions point by point.
For all adjustments the device must be completely shut down!
By carriyng out any adjustment operations, ensure, that nobody is located in the movement area of the
hydraulic installation clamp, when actuating any hydraulic functions.
Danger of injury to hands!
Never carry out any adjustment operations while hydraulic functions are actuated.
All movements have to be slowly and carefully, otherwise damages may occur.
5.2
Adjustment of the feather-steel-lamellas
•
The feather-steel-lamellas should not stitch out sideways over the contour of the laying cluster, because they
could hit the already laid blocks when laying a new cluster into an edge.
Depending on the length of a pack, the lamellas, which are stitching over, should be replaced by the 1.5-lamella
or the half-lamella.
•
It can be advantageous or even necessary to use special feather-steel-lamellas for certain stone layer systems
(e. g. hexagonal stones). Contact, if necessary, the manufacturer of the hydraulic installation machine (HVZ).
Fig. 1
Tighten the self-locking nuts tight and then loosen them again by 1/2 turn. In order to give the feather-steel-lamellas
a higher flexibility and therefore a good, secure and gentle grip to the pavers.
51400035
When mounting the screws with the feather-steel-
lamellas, pay attention to the configuration of the three
spring washers as shown on the drawing (Fig. 2).
Disc springs
Steel lamella
Fig. 2
17 / 35
GB
