Stihl TS 400 Cutquik Manual De Instrucciones página 42

Idiomas disponibles

Idiomas disponibles

:
Fit a new spring housing with the
bottom upwards and guide the outer
spring loop round the lug
:
Refit the rope rotor
:
Tension the rewind spring
:
Refit the fan housing and screw it
into place
If the spring has popped out of the
spring housing:
:
Replace it, working anticlockwise
from the outside inwards
TS 400
Replacing the V-belt
3
3
4
3 1
:
The arrow on the tensioning nut (1)
must point to "0".
:
Turn the tensioning nut approx.
1/4 turn anticlockwise as far as the
stop = "0" with the combination
wrench.
:
Unscrew the hexagon bolts (2)
:
Remove the V-belt guard and
bearing with guard
:
Undo the screws (3) in the starter
cover
:
Remove the starter cover
:
Remove the defective V-belt form
the cast arm
:
Carefully insert the new V-belt in the
cast arm and in the V-belt pulley on
the engine
:
Fit the starter cover
:
Hold the bearing with guard against
the cast arm
2
2
:
Insert the V-belt in the V-belt
pulley (5)
:
Line up the threaded bores in the
bearing plate with the slots in the
cast arm
:
Fit the V-belt guard
:
Screw in the hexagon bolts (2) as
far as the stop, but do not tighten
them yet
Continue as described in the
chapter "Tensioning the V-belt".
English / USA
5
41
loading