Idiomas disponibles
Idiomas disponibles
To tension the V-belt:
:
Fit the combination wrench over the
tensioning nut as illustrated
The tensioning nut is spring-loaded:
the combination wrench must
therefore be held securely!
:
Turn the tensioning nut clockwise.
The spring force begins to act on the
tensioning nut after approx. 1/8 turn
and turns it on as far as the stop
(approx. 1/8 turn)
Do not use force to turn the combination
wrench further!
TS 400
1
The V-belt is automatically tensioned
by the force of the spring in this position.
:
Remove the combination wrench
from the tensioning nut and
tighten the three hexagon bolts on
the V-belt guard
Retensioning
The V-belt is retensioned without
adjusting the tensioning nut
:
Unscrew the hexagon bolts (1) on
the V-belt guard
:
The V-belt is automatically
tensioned by the force of the spring
:
Retighten the hexagon bolts
English / USA
Abrasive wheels
The abrasive wheels are subjected to
extremely high loads, especially when
cutting free-hand.
The abrasive wheels developed by
STIHL in cooperation with leading wheel
manufacturers are of very high quality
and precisely matched to the application
in question, as well as to the engine
power of the respective cut-off
machines.
They are of consistently outstanding
quality, with high axial and radial runout.
Transport and storage
–
The abrasive wheels must not be
exposed to direct sunlight or other
sources of heat during transport and
storage
–
Avoid knocks and bumps
–
Spare abrasive wheels must be
stored in a dry place at constant
temperature, stacked one on top of
the other on a flat surface, in their
original packaging.
–
Diamond abrasive wheels must not
be stored near corrosive liquids
–
Composite abrasive wheels must
be protected against frost
27
