Assembling The Chain Saw; The Cutting Attachment; Mounting And Removing The Guide Bar And Saw; Mounting The Guide Bar And The Saw Chain - Stihl MSA 120 C Manual De Instrucciones

English
If the LED glows green continuously: the battery
is being charged.
or
The battery is too hot or too cold for charging. To
determine, check the LEDs on the battery. If
there is one glowing red light, allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
If the LED flashes red: there is no electric contact
between the battery and the charger. Remove
and reinsert the battery.
or
The battery has a malfunction and must be
replaced. Check the LEDs on the battery. Do not
use or charge a battery if its LEDs indicate a
malfunction.
or
The charger has a malfunction. Have it checked
by an authorized STIHL servicing dealer before
use.
For more information, @ 25.

15 Assembling the Chain Saw

15.1 The Cutting Attachment

WARNING
If non-matching components are used, the cutting
attachment will be damaged beyond repair after a short
period of operation, and the chain could de-rail, resulting in
serious or fatal personal injury.
A cutting attachment consists of the saw chain, guide bar
and chain sprocket. The cutting attachment that comes
standard with this model chain saw is designed to match the
chain saw.
38
1
a
t = a 2
– The pitch (t) of the saw chain (1), chain sprocket and, if
applicable, the nose sprocket of the Rollomatic guide bar
must match.
– The drive link gauge (2) of the saw chain must match the
groove width of the guide bar (3).
15.2 Mounting and Removing the Guide Bar and
Saw Chain

15.2.1 Mounting the Guide Bar and the Saw Chain

WARNING
Make sure the battery is removed and the chain brake is
engaged before starting assembly. Never operate your
chain saw without a properly mounted guide bar and saw
chain, @ 6.5. Use only guide bar and saw chain
combinations expressly recommended or approved by
STIHL, @ 6.4.
WARNING
The saw chain has many sharp cutters. If they contact your
flesh, they will cut you, even if the saw chain is not moving,
@ 6.4. Always wear heavy-duty work gloves when
mounting or otherwise handling the saw chain, @ 6.3.
To mount the guide bar and saw chain:
► Switch off the chain saw, @ 18.1.
► Engage the chain brake, @ 16.1.
► Remove the battery, @ 17.2.
15 Assembling the Chain Saw
2
3
0458-716-8621-D