Idiomas disponibles
Idiomas disponibles
English / USA
Starting
!
Warning!
Your cut-off machine is a one-person
tool. Do not allow other persons to be
near the cut-off machine. Start and
operate your cut-off machine without
assistance. For specific starting
instructions, see the appropriate section
of your instruction manual.
10
Do not drop start. This method is very
dangerous because you may lose
control of the cut-off machine.
Place the cut-off machine on firm ground
or other solid surface in an open area.
Maintain good balance and secure
footing. Be absolutely sure that the
cutting wheel is clear of you and all other
obstructions and objects, including the
ground. When the engine starts at
starting-throttle, engine speed will be
fast enough for the clutch to engage the
V-belt pulley and turn the wheel. Never
attempt to start the cut-off machine
when the abrasive wheel is in a cut.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
!
Warning!
When you pull the starter grip, don't
wrap the starter rope around your hand.
Do not allow the grip to snap back, but
guide the starter rope slowly back to
permit the rope to rewind properly.
Failure to follow this procedure may
result in injuries to hand or fingers and
may damage the starter mechanism.
Working Conditions
Operate the cut-off machine under good
visibility and daylight conditions only.
Wearing of hearing protection reduces
sound perception. Be alert not to miss
voice signals from co-workers. Keep
within calling distance to other persons
who may assist in case of emergency.
!
Warning!
Your cut-off machine
produces toxic exhaust
fumes as soon as the
combustion engine is
running. These gases
(e.g. carbon monoxide)
may be colorless and odorless. To
reduce the risk of serious or fatal injury
from breathing toxic fumes, never run
the cut-off machine indoors or in poorly
ventilated locations. Ensure proper
ventilation when working in trenches or
other confined areas.
TS 400
