Cramer 82LT107 Manual Del Usuario página 6

EN
3.4 ANTI-SCALP WHEELS
See figure 2
Anti-scalp wheel kits are standard on Cramer units. These anti-scalp wheels are designed to minimize scalping when
mowing on rough, uneven terrain. After setting the cutting height, adjust the anti-scalp wheels so they extend below
the deck but do not contact the ground. They should always be at least 0.6 cm to 1.9 cm below the deck. With the
unit sitting on a flat level surface, the wheel position can be adjusted up or down as needed from 1.9 cm to 4.4 cm
below the blade surface. Move the wheels up or down - using the different axle mount holes in the wheel mount
bracket (if applicable on model).
3.5 USE THE APP
See figure 7-8
1. Visit the website of Fleet Management: fleet.cramertools.com
2. Create an account and then log in.
3. Invite other users in your organization.
4. Scan the QR code, download the app and log in.
5. Add a device. Find the serial number, pairing code and QR code in the vehicle matching label on this manual.
Scan QR code or type in manually.
4 OPERATING INSTRUCTIONS
4.1 BEFORE OPERATION
4.1.1 ADJUST THE SEAT
See figure 9
Adjust the seat position to ensure you are able to make firm contact with the accelerator and brake pedal before
operating the mower.
1. Sit down on seat and lift the seat adjustment lever.
2. While holding the lever, slide the seat to the desired position.
3. Release the lever and make sure the seat is locked in position before operating the mower.
Be sure the seat is locked into place before operating the mower. A seat that is not secure can cause the operator
to shift and lose control of the mower and result in possible death or serious personal injury.
4.1.2 ADJUST THE DECK CUTTING HEIGHT
See figure 10
Before using the mower, raise the deck height to the cutting position best suited for your lawn.
Deck height is adjustable from 3.81-11.4 cm. Deck should be raised while mowing is in progress to avoid stumps,
rocks or other obstacle that can be damage mower deck.
Hold the deck height adjustment lever firmly when setting the deck height and only release when it is secure in the
desired slot. Quickly letting go of the lever may create a pinching or pulling hazard to the operator's hand.
1. Stop the mower and disengage blades.
2. Turn the key to OFF position and set the parking brake.
3. To raise the cutting deck, grasp the deck height adjustment lever, push left to disengage from slot, move toward
the back of the mower, then push right into slot to secure.
4. To lower the cutting deck, grasp the deck height adjustment lever, push left to disengage from slot, move toward
the front of the mower, then push right into slot to secure.
English
WARNING
CAUTION
6