Cramer 82LT107 Manual Del Usuario página 5

• If parts of the machine are damaged, do not use the machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with local regulations.
For your personal safety, do not insert battery before the tool is assembled completely.
3 INSTALLATION
3.1 INSTALL THE SEAT
See figure 3
1. Place the seat assembly over the seat panel and align holes as shown.
2. Install the bolts, washers and nuts and tighten securely.
3. Attach the sleeves to the nuts.
4. Make sure it is securely seated.
5. Connect the seat plug to the machine.
3.2 INSTALL THE STEERING WHEEL
See figure 4-5
Make sure the slot faces up to the seat.
1. Install the steering shaft into the coupler, rotating as needed to align hole in shaft with bolt hole in coupler.
2. Install two bolts and tighten securely.
Torque bolts to the value as shown.
3. Install the steering column. Note the tabs on the bottom of the steering column that fit into the holes in the
opening and make sure steering column is securely seated.
4. Make sure the mower's wheel is pointed straight ahead, then install the steering wheel over the steering column
with force.
5. Install the bolt and washer; tighten securely.
6. Install the steering wheel cover plate.
3.3 INSTALL THE MULCH COVER
See figure 6
The mower is configured for side discharge when shipped. If mulching is desired:
1. Place the mulch cover on the tab on the mower housing.
2. Align the holes in the mulch cover and the holes in the mower housing.
3. Install and tighten the bolts, screws, fixation clamps and bearing ring as shown.
English
WARNING
WARNING
NOTE
NOTE
5
EN