Cramer 82LT107 Manual Del Usuario página 12

EN
6.1 ERROR CODE
Error Code
T11
T12
T13
T14
T15
T16
T17
T18
T21
T22
T23
T25
T26
T27
T28
V14
V15
V16
V17
Description
Overvoltage
Undervoltage
Controller self-test error
Drive motor stalled
Motor encoder error
Controller driver circuit error
Drive part of controller overtemp
Drive motor overheat
Temperature sensor of the drive
motor abnormal
Drive part of controller hardware
overcurrent
Pre-charge error
Drive software overcurrent
Drive MOS error
Motor phase loss
Drive controller overtemp
Reverse mowing operation se-
quence incorrect
Vehicle self-test error
Operation sequence incorrect
SPI communication error
English
Solution
The voltage is too high. Restart the power supply.
The voltage is too low. Charge the battery pack before use.
If you encounter this issue, contact your distributor for a
solution.
Check if the drive wheels are stuck and restart the power
supply.
Check that the Hall-effect connector of Drive controller is
properly connected, and then restart the power supply.
If you encounter this issue, contact your distributor for a
solution.
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply.
The motor temperature is too high. Wait for the motor to cool
down, and then restart the power supply.
Check the wiring of the temperature sensor for abnormali-
ties.
The load is too high. Restart the power supply.
Restart the power supply.
The load is too high. Restart the power supply.
If you encounter this issue, contact your distributor for a
solution.
Check that motor cables of the Drive controller are connec-
ted properly, and then restart the power supply.
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply.
Please press the reverse mowing button before reverse
mowing.
1. Before starting the vehicle, check that the brake is in the
engaged position.
2. Before starting the vehicle, place the cutter switch in the
off postion and check that the cutter switch is connected
properly.
3. Before starting the vehicle, place the FNR gearstick in
the N position.
4. Check that the connector underneath the seat is connec-
ted properly.
5. Do not press the cruise control button when starting the
vehicle.
6. Do not press the accelerator pedal when starting the
vehicle.
Return the accelerator and blade switch to their initial posi-
tions.
Restart the power supply.
12