Drilling Without Hammering; Drilling With Hammering Action (Hammer Drilling) - Hilti TE 50 Manual De Instrucciones Original

5. Adjust the depth gauge to the desired drilling depth.
6. Tighten the screw at the depth gauge.
6 Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any
attempt is made to operate the tool without an earth/ground conductor
and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used,
always make sure that an earth/ground conductor and ground fault
circuit interrupter are present in the power supply and that these are
correctly connected.
▶ Do not use the product unless these safety measures are in place
and fully operational.
Observe the safety instructions and warnings in this documentation and on
the product.

6.1 Drilling without hammering

Note
Drilling without hammering action is possible when accessory tools with
a special connection end are used. Accessory tools of this kind are
available from Hilti.
Alternatively, when the keyless quick-release chuck is fitted, smooth-
shank drill bits for wood or steel, for example, can be used to drill
without hammering.
▶ Set the function selector switch to the

6.2 Drilling with hammering action (hammer drilling)

1. Set the function selector switch to the
2. Press the drill bit against the work surface.
3. Press the control switch.
◁ The product starts.
6.3 Chiseling
▶ Set the function selector switch to the
10 English
Printed: 08.03.2017 | Doc-Nr: PUB / 5070997 / 000 / 03
position.
6
position.
position.