Idiomas disponibles
Idiomas disponibles
CHARGING INDICATOR
Light
ON/OFF
Red on
Green on
OPERATION
1. ON / OFF SWITCH (See Fig. B)
Depress the On/Off switch to start and release it to stop
your drill. The on/off switch is fitted with a brake function
which stops your chuck immediately when you quickly
release the switch.
It is also a variable speed switch that delivers higher speed
and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
WARNING: Do not operate for long
periods at low speed because excess
heat will be produced internally.
2. SWITCH LOCK
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control in the center position.
3. REVERSIBLE
For drilling and screw driving use forward rotation marked
"
" (lever is moved to the left). Only use reverse rotation
marked "
" (lever is moved to the right) to remove
screws or release a jammed drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
4. CHUCK ADJUSTMENT (See Fig. C)
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and rotate
the front section in the opposite direction. Ensure the drill bit
is in the center of the chuck jaws. Finally, firmly rotate the
front chuck section in the opposite directions. Your drill bit is
now clamped in the chuck.
5. TORQUE ADJUSTMENT (See Fig. D)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment ring
is set on a higher setting. The torque is less when the torque
adjustment ring is set on a lower setting.
Make the setting as follows:
16
1 - 4
Status
5 - 9
Charging
10 - 18 For driving screws into soft and hard material
Fully Charged
6. USING THE LED LIGHT
The sight light allows you to keep a clear view under less
illuminated circumstances. To turn on the light simply press
the on/off switch. When you release the on/off switch, the
light will be off.
7. DRILLING
When drilling into a hard smooth surface, use a center
punch to mark the desired hole location. This will prevent
the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point
to be drilled. Depress the switch trigger to start the tool.
Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force or apply side
pressure to elongate a hole.
drilling in metal, only use HSS drill bits in good condition.
Always use a magnetic bit holder (not included) when using
short screwdriver bits. When screw-driving, apply a small
quantity of liquid soap or similar to the screw threads to
ease insertion.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of
the trigger, is positioned in the lock function. Unlock the
forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring,
you can find the torque-adjusting ring between the chuck
and the drill body. Position 1 is the lowest torque (screw
driving force) and position 18 is the highest torque (screw
driving force). Position 19 is for drill operation. Regulate
the torque adjusting ring to a higher position to reach the
best result.
For driving small screws
For driving screws into soft material
For heavy drilling
WARNING: Tungsten carbide drill bits should
always be used for concrete and masonry. When
EN
