Idiomas disponibles
Idiomas disponibles
EN
1.4.8
Construction cylinders (HCJ) (Fig. 7)
Construction cylinders are meant to be used in already existing construction.
WARNING
In case of thread of the cylinder and plunger end is used, use the full length of the thread.
The threaded holes in the bottom of the cylinder are intended for positioning only and are
not capable for the full load or constructiob purposes.
1.4.9
Flat cylinders (HFC) (Fig. 10)
Flat cylinders are used in places with a minimum of space to place the cylinder.
1.4.10
Short stroke cylinders (HSC) (Fig. 10)
Short stroke cylinders are used in places with a minimum of space to place the cylinder.
1.4.11
Workability
The workability and life span of the product strongly depend on a numbers of circumstances. Usage
intensity and the geometry and weight of the load are examples of these circumstances. When in doubt
about the workability or life span of this product, contact Holmatro in any event.
1.4.12
System requirements
Because of the diversity in control, operating pressure and required oil volume per tool, not all
combinations of Holmatro pumps, hoses and tools can be applied. In case of doubt about the
compatibility of the system, always consult the Holmatro dealer.
•
The tool may only be operated with a Holmatro hydraulic pump.
•
Because of the universal field of application of the tool, not all system combinations can be
described. Make sure you use the correct accessories, such as (check) valves or manifold blocks.
1.5
Qualified personnel
The system may only be operated by people trained in its use. Always obey local legislation, safety and
environmental regulations. Repair work may only be performed by a Holmatro Certified Technician.
1.6
Guarantee
Refer to the general terms and conditions of sale for the guarantee conditions, available from your
Holmatro dealer on request.
Holmatro draws your attention to the fact that every guarantee on your piece of equipment or system
will lapse and that you must indemnify Holmatro against any possible product liability and responsibility
if:
•
service and maintenance are not carried out strictly in accordance with the instructions, repairs are
not performed by a Holmatro Certified Technician or are performed without prior written consent;
•
self-made changes, structural changes, deactivation of safety devices, injudicious adjustment of
hydraulic valves and faulty repairs have been carried out;
•
non-genuine Holmatro parts or hydraulic oils or lubricants other than the types prescribed are used;
•
the piece of equipment or the system is used injudiciously, through errors of operation, improperly,
negligently or not in accordance with its nature and/or purpose.
•
the maximum flow of pump, as specified in section 3.3, is exceeded.
1.7
Declaration of Conformity
Holmatro B.V. declares under its sole responsibility that this multi purpose cylinder is in conformity with
the standards and directives as described in section 3.3.
The original Declaration of Conformity is supplied with the tool.
32
916.000.851_007
HYDRAULIC CYLINDERS
