Rohde ST 410 Instrucciones De Uso página 57

Display Icon
En d
d f
*The keys or can also be held down for faster input.
Note:
 It is possible to exit programming mode without performing all of the steps described above. To do this, wait 20
seconds without pressing a key and the controller will revert to the idle display. All changes are automatically
applied and saved immediately.
 Alternatively, exit the programming mode with the
made are automatically saved, however.
h g
 The or keys can be used to cycle through the programming steps to correct errors or to exit
programming mode.
 The switch output (event) can be added or deselected by pressing the switch output (event) key while
programming the heating ramp, cooling ramp and soak time (see Section 7.).
6.5.2. Changing the firing program: Programming the heating or cooling ramp
When changing the firing program, the heating rate in the firing segment often has to be changed from a heating ramp
to a cooling ramp and vice versa.
Heating ramp:
If the soak/target temperature of the selected segment is higher than or equal to the soak/target temperature
of the previous segment, the controller displays a heating ramp in the selected segment.
Cooling ramp:
If the soak/target temperature of the selected segment is lower than or equal to the soak/target temperature
of the previous segment, the controller displays a cooling ramp in the selected segment.
Changing a heating ramp to a cooling ramp:
Display Icon
Pr. 1
3
150
Meaning Description
To mark the end of the program:
End program input


 Program input is also automatically terminated if the maximum
 If "END" is not entered in the last segment, the controller
Meaning Description
Select the firing program that
Program number
is to be changed.
Select the segment with the
Indicator in the
heating ramp to be changed
segment display
into a cooling ramp.
Heating ramp
Press the
the soak or target
temperature.
55 / 291 - EN -
f
Push the key until "END" appears in the main display.
To end the program input, press the
number of segments have been entered.
issues the error message "Error P" when the program starts.
j
key and start the firing process immediately; all changes
g
key to switch to
f
key.
Remark
See Section 6.4.1.
See Section 6.4.1.
A heating ramp is set in the
selected segment.