Idiomas disponibles
Idiomas disponibles
4.4.
Control unit extension cable
If the bracket for the control unit is attached at the operation location (near the kiln or mounted on a wall), the
cable can be extended using an extension cable.
The extension cable for the control systems is optionally available in lengths of 2.5, 5 or a maximum of 10
meters.
Note on extension cables and environmental influences due to EMC:
To meet the requirements for electromagnetic compatibility (EMC), the length of the controller
connection cable should not exceed 3 meters.
If the controller is connected to the kiln with an extension cable, it should be ensured that there is no
electrical device in the direct vicinity of the cable (electromagnetic stray field).
Otherwise, a loss of accuracy of up to 3°C could occur.
4.5.
Third-party kiln note
The wiring of the mating CPC 14 socket on the kiln can vary between kiln manufacturers!
Attention!
If the assignments of the controller and kiln do not match, then there is a risk of damage to both the controller and kiln.
5.
Installation
5.1.
Switching the control unit on & off
The rocker switch for switching the control unit on and off is located on the underside of the housing.
Switching the
control unit on
Switching the
control unit off
5.2.
Quick start guide
Switch on and wait for the kiln temperature display.
Call up firing programs with the
Select the firing program with the
To start the selected program, press the
To stop the firing at any time, press the
The firing data and the programming mode can be called up again with the
Change the firing data and change the displayed value with the
g
Use the
key again as necessary to step to the next firing value or segment to be reviewed or changed.
h
Use the
key to switch back to the previous value.
To mark the end of a program, set the ramp rate to END with the
To exit programming mode, either wait 20 seconds or press the
Set the rocker switch to position "I".
Set the rocker switch to position "0".
g
key.
f
d
or
key.
j
key.
j
key again.
49 / 291 - EN -
g
key.
f
d
or
keys.
f
key.
j
key to start firing.
