Idiomas disponibles
Idiomas disponibles
Heating
DHW
Installation
Heat recovery
Burner status:
Air quality sensor 1:
Control elements
Menu introduction
Competent person contact info
Phone number
Company
Serial number
2.14.3
SETTINGS menu item
MENU
SETTINGS
Installer level
Enter access code
End external Energy Manager
Competent person contact info
Service date:
Fault history
Installation configuration
Sensor/actuator test
Noise reduction mode
Screed drying
Change code
Language, time, display
Language:
Date:
Time:
Display brightness:
Dimmed displ. brightness:
Daylight saving time:
Automatic
Manual
66
Current month, Last month, Current year, Last year, Total
Current month, Last month, Current year, Last year, Total
Current month, Last month, Current year, Last year, Total
Amount of energy saved by the ventilation unit
Current burner status of the connected boiler
Measures the CO
content of the room air
2
Explanation of the control elements
Explanation of the menu structure
The competent person can store their telephone number.
Identification of the product. The 7th to 16th digits of the serial
number form the article number
Access to the installer level, factory setting: 00
If the access code is unknown, reset the system control to the fact-
ory setting.
After ending, the system control re-assumes its control function
with its original settings.
Entering contact details
Enter the next service date for a connected component, e.g. heat
generator, heat pump, ventilation unit
Faults are listed in chronological order
Installation configuration menu item (→ section 2.14.4)
Selecting a connected functional module and
–
carrying out a function check of the actuators.
–
Carry out a plausibility check of the sensors.
Set the time programme in order to reduce the noise level.
Activate the Screed drying profile function for freshly laid screed
in accordance with the construction regulations.
The system control regulates the flow temperature independently
of the outdoor temperature.
Set screed drying
Installation configuration menu item (→
section 2.14.4)
Defining an individual access code for the installer level
Defining the language that is to be shown on the display.
After the power is switched off, the date is retained for approx. 30
minutes.
After the power is switched off, the time is retained for approx. 30
minutes.
Brightness during active use.
Brightness in standby.
Define whether daylight saving time should be used.
For outdoor temperature sensors with DCF77 receivers, the Day-
light saving time: function is not used. The conversion to sum-
mer/winter time takes place via the DCF77 signal.
The change takes place automatically:
–
On the last weekend in March at 02:00 (daylight saving time)
–
On the last weekend in October at 03:00 (standard time)
The Daylight saving time: function is not used. The time does not
change automatically.
Operating and installation instructions 0020287900_03
