Idiomas disponibles
Idiomas disponibles
16
when carrying out adjustments
The EM 300 chair has two quick-release
belts to immobilise the patient during tran-
sport.
One belt is located on the back of the
seat, to block the chest zone and the se-
cond one is located on the seat itself to
block the legs.
The quick-release belt is composed of
two parts: a xed part (female) and an
adjustable part (male) equipped with two
hooks (Figure G).
Release the belts as illustrated in Figure
E-F-G.
The fast-release procedure must be car-
ried out by applying a pressure on the hoo-
ks as illustrated in Figure F and by pulling
outwards the two parts.
Release the belts by letting the excee-
ding part slide on the hook.
Join the two parts until you hear the
typical fastening sound (click).
Pull the free part of the belt until com-
plete and correct immobilisation of the
patient.
Extracting the front transport levers
E
F
G
WARNING! ALWAYS tell the patient
when carrying out adjustments
To carry out this operation you must:
•
lift the pawl (6) with one hand;
•
extract the front transport lever
(7) with the other hand;
•
release the pawl and move the
transport lever slightly back or forth
until the locking device (6) snaps shut
(click).
Figure I and L show all the steps.
Moving the chair
6
1
WARNING! The chair must be operated
by two average height persons in
good physical conditions. In particular
operators must possess sufficient
strength in their back, arms and legs
to lift, pull and push in addition to
good physical balance, re exes and
muscular co-ordination.
WARNING! When moving the chair
while the patient is sitting on it, always
insert the locking pawls and fasten the
safety belts.
To move the chair on smooth surfaces:
•
foot on the inclination hub (9);
•
degrees while maintaining the fulcrum
on the hub and lever on the handles
(2);
•
the handles (2);
7
•
wheels by acting on the hub (9) and set
upright slowly, without sharp move-
ments;
To move the chair in uncomfortable lo-
cations (stairs), just do as follows:
•
of the rear transport levers (1);
I
•
and lock the front transport levers (7)
as indicated in the previous section;
•
L
patient slowly but simultaneously;
•
come, put the chair on the ground and
close the front transport levers.
WARNING! Before moving the chair
verify that the locking pawls are
correctly inserted.
Requirements for operators and
7
The operators:
9
lock the wheel by putting your
bend the chair backwards for forty
push or pull the chair by holding
at the end of the way re-lock the
the rst operator must lift the bar
the second operator must extract
both must lift the chair and the
once the obstacle has been over-
their training
