Idiomas disponibles
Idiomas disponibles
15.4
Operating
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before carrying out any
adjustment or conversion work and secure it against unintentional
reconnection.
Clamping the workpiece
Longitudinal travel
HOLZMANN Maschinen GmbH
The drill tip should be adjusted to a distance of 0.8 to
Close the drill chuck cover
Fasten the screw of the drill chuck cover
WARNING
Place the workpiece on the work table
Set the workposition with the workpiece stop (5) on the
Clamp the woork piece with the workpiece clamping (2)
Close the workpiece downholder (3) and fix the workpiece
Set the desired longitudinal travel with stops (1) (read off
Loosen the locking screw (3)
Move the work table in the desired direction with the
www.holzmann-maschinen.at
1.6 mm between the chisel points depending on
the type of wood
work table stop (4)
and lock with the locking lever (1)
the scale (2)).
handwheel longitudinal travel (4)
OPERATION
35
STM26 | STM26S
