Idiomas disponibles
Idiomas disponibles
Do not use the machine in areas where vapours of paints, solvents or flammable liquids
•
represent a potential danger (danger of fire or explosion!).
Shut down the machine and disconnect it from the power supply, before adjustment,
•
changeover, cleaning, maintenance or repair work, etc. Before starting work on the
machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restart.
Warning signs and/or stickers on the machine that are illegible or have been removed must
•
be replaced immediately!
12.5
Electrical safety
Make sure that the machine is grounded.
•
Only use suitable extension cables.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
•
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
Proper plugs and outlets reduce the risk of electric shock.
•
•
Water entry into the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
The machine may only be used if the power source is protected by a residual current circuit
•
breaker.
Use the machine only when the ON-OFF switch is in good working order.
•
Before connecting the machine always make sure that it is switches off.
•
12.6
Special safety instructions for this machine
During operation of the machine wood dust is generated. Work only in well-ventilated
•
rooms and wear a dust musk!
•
Keep the machine away from potential ignition sources such as open flames – risk of fire
and explosion!
If an original machine stand is not used, the machine must be fixed firmly on a stable
•
worktable or workbench. The working height should be 850 mm.
The workpiece to be machined must be free of foreign objects such as nails or screws.
•
Never remove sections or other parts of the workpiece from the working area while the
•
machine is running.
•
Replace cracked and deformed mortise drills immediately, they cannot be repaired.
•
Use clean and sharpened mortise drills, which are less sensitive to malfunctions and easier
to guide.
•
Always fix workpieces with workpiece clamping and workpiece downholder.
For a workpiece that is wider or longer than the supporting table, sufficient support such as
•
table extensions, saw blocks, etc. must be provided.
12.7
Hazard warnings
Residual risks
Despite intended use, certain residual risk factors remain.
Danger of cutting hands/fingers or other other parts due to sharp mortise drills.
•
Risk of injury to hands/fingers due to crushing between moving and fixed parts (hold-down
•
devices, stops, workpiece supports,...).
Risk of injury due to tipping of the machine.
•
•
Risk of injury due to improper maintenance activities.
Hazardous situations
Due to the structure and construction of the machine, hazardous situations may occur which are
identified in these operating instructions as follows:
HOLZMANN Maschinen GmbH
DANGER
www.holzmann-maschinen.at
SAFETY
29
STM26 | STM26S
