TRAPP Master 500L Manual De Instrucciones página 26

Advance and automatic cutting of the
nylon line
1. With the equipment running:
Slightly press the spool (1) against the ground.

The nylon line will automatically be released.
The cutting blade fixed to the protection
device will limit the amount of wire released.
Press the spool against the ground as many

times as necessary.
In order not to damage the equipment or the

protection device, only press the central part
of the spool against the ground.
2. You may want to carry out this operation manually:
Unplug the equipment.

Press the central part of the spool (1) with one

hand and with the other pull the nylon line (2)
in the necessary length.
2
Image merely illustrative
Fixing the extension cord to the
equipment
2
To use this system, do as shown in the next figure:
Put the extension cord in hole (1).

Pass the cord over the lock (2).

26
1 1
Image merely illustrative
1
1
Connect the equipment plug to the extension

cord (3).
1
1
Image merely
illustrative
Wheel mounting
Slide wheels (I) onto wheel support (2). Position

clamp (3) on aluminum shaft (4). Place the wheel
support (2) into the clamp fitting (3), sliding
the wheel support's (2) fitting downwards into
the clamp fitting (3). Ensure that the locking
mechanism (5) is in the position shown in the
image. Once the wheel support (2) is fitted into
the clamp (3), lower the lever (5) in the direction
of the arrow to lock the unit into place.
4
4
3
5
5
www.trapp.com.br
3 3
2
2
2
2
1
1
Image merely illustrative