Checking The Spark Plug; Blade Replacement - Garland 1480 TQG Manual De Instrucciones

at the end of the tube to prevent oil spilling on the
machine or the ground).

7.2.3. CHECKING THE SPARK PLUG

When it comes to starting a machine, the most
common problems are produced by a dirty spark plug
or one in poor condition. Clean and check the spark
plug regularly.
Check that the electrode gap is correct (0.6 - 0.7
mm).
7.2.4. OIL EXTERNAL BEARING
7.2.5. LUBRICATE THE INNER BEARING

7.2.6. BLADE REPLACEMENT

ATTENTION! Always wear safety gloves when
working with blades.
This machine is equipped with two reversible blades.
When they lose the edge the blades can be turned to
use the second edge. When the second edge is spent
they have to be replaced. It is often possible that the
cutting edge is worn because the vibration increases,
it is difficult for the material to enter the blades and /
or once crushed it comes out in long strips.
7.2.7. REPLACEMENT OF THE COUNTER KNIFE
The counter knife is also reversible. When the edge of
the counter blade is rounded it can be rotated. When
43/148
English