Silvercrest SMA 500 E1 Manual De Instrucciones E Indicaciones De Seguridad página 39

7.6 Making warm milk froth
•
Insert whisk (4) up to the stop on the drive shaft inside the canister (6).
•
Take the canister (6) off the base (10) and pour milk up to the MIN marking inside the canister
(6). The volume of the milk increases during the frothing process. Only pour milk up to the
lower MAX marking in order to prevent the milk froth from overflowing.
•
Place the lid (2) onto the canister (6).
•
Place the canister (6) onto the base (10).
You can make two types of warm milk froth as described in section 7.3:
•
Use the button (8) to select operating mode 1. The symbol of the operating mode 1 (12)
flashes and the whisk (4) begins to turn after approximately three seconds. The process
of creating milk froth begins.
or
•
Use the button (8) to select operating mode 2. The symbol of the operating mode 2 (13)
flashes and the whisk (4) begins to turn after approximately three seconds. The process
of creating milk froth begins.
•
As soon as the milk froth is ready, the milk frother automatically switches off and the symbol of
the selected operating mode (12, 13) flashes, it then goes out again after a short time.
You can stop the preparation process at any time by briefly pressing the button (8).
•
Wait around 30 seconds until any remaining fluid milk settles at the bottom of the canister (6).
•
Lift the canister (6) off the base (10), remove the lid (2) and use the milk froth as you wish.
•
Wait two to three minutes before using the milk frother again.
7.7 Making cold milk froth
•
Insert whisk (4) up to the stop on the drive shaft inside the canister (6).
•
Take the canister (6) off the base (10) and pour milk up to the MIN marking inside the canister
(6). The volume of the milk increases during the frothing process. Only pour milk up to the
lower MAX marking in order to prevent the milk froth from overflowing.
•
Place the lid (2) onto the canister (6).
•
Place the canister (6) onto the base (10).
•
Use the button (8) to select operating mode 4. The symbol of the operating mode 4 (9) flashes
and the whisk (4) begins to turn after approximately three seconds. The process of creating
milk froth begins.
•
As soon as the milk froth is ready, the milk frother automatically switches off and the symbol of
the selected operating mode (9) flashes; it then goes out again after a short time.
SilverCrest SMA 500 E1
English - 37