Idiomas disponibles
Idiomas disponibles
Lifting the work vehicle
WARNING
During the lifting phase, use lifting ropes and hooks
in perfect condition and with a suitable lifting capac-
ity and lifting means with higher lifting capacity than
the load to be lifted.
The staff assigned to handling the load must have the
required ability and experience and must be skilled
in the use of the lifting means adopted.
The illustration shows the harnessing points and lifting
procedure.
Safety advice for the adjustments
Adjustment work must be carried out with the work
vehicle on flat, compact ground, with the machine
resting on the ground (except where expressly stat-
ed otherwise in the manual).
Rear conveyor adjustment
Adjust the chutes to vary the amount of
crops allowed to pile up.
Carry out the operations described.
1) Loosen the knob (A).
2) Use handwheel (B) to change the tilt
of the chute (C).
The more the chute is tilted with re-
spect to the ground, the less the crops
will pile up in the windrow and vice
versa.
3) Tighten the knob (A).
If the rubber strip (D) pierces the ground
during work, adjust it as stated.
1) Unscrew the nuts (E).
2) Remove the screws (F).
3) Move the rubber strip upwards until
its fastening holes coincide with the holes on the
chute.
4) Insert the screws (F).
English language
INFORMATION CONCERNING HANDLING AND INSTALLATION
ADJUSTMENT INFORMATION
F
UN41-0818LR
UN41-0817LR
The tractor engine must be switched off, the parking
brake engaged, and the ignition key removed, and
all the necessary safety measures required to work
safely must be taken.
E
D
5) Tighten the nuts (E).
Repeat the same steps to adjust the chute on the other
side.
10
B
C
A
Use and maintenance
4
5
