Mounting The Motor - RIDGID BS1400 Manual Del Propietário

Assembly (continued)

Mounting The Motor

1. From the loose parts bag find the fol-
lowing items:
4 M8 x 35 Hex Cap Bolts
(approx. 1-3/8")
8 M8 Washers
4 M8 Lockwashers
4 M8 Nuts
4 Rubber Grommets
2. From the loose parts find the following
items:
1 Motor
1 V-Belt
3. To mount motor, place four rubber
grommets over holes in stand top.
NOTE: Use of rubber grommets is
essential for eliminating excessive
vibration. Place motor over rubber
grommets and fasten to stand top with
four hex head bolts, eight washers,
four lockwashers, and four hex nuts, as
shown. Do not tighten at this time.
4. Align the inside edge of the motor pul-
ley with inside edge of the large pulley
using a straight edge. Using a 3mm
hex "L" wrench, adjust one or both pul-
leys by loosening the set screw and
moving the pulley(s) until they line up
with each other. Tighten set screws.
5. Place V-belt over both pulleys.
6. Tension V-belt by moving motor away
from the saw body and tighten the
motor mount nuts. (Do not over-tighten
motor mount bolts. Tighten just enough
to tension belt.) Belt is properly ten-
sioned when finger pressure between
the two pulleys causes approximately
1/2" deflection.
Bolt Hex Head
M8 x 1.25-35
Washer M8
Lockwasher
M8
Bolt
Washer
Grommet
18
Rubber
Grommet (4)
Nut Hex M8
Motor w/
Switch
V-Belt
Motor
Washer
Lockwasher
Nut