Mounting The Scroll Saw; Workbench Applications - RIDGID SS1650 1 Manual Del Usuario

Mounting the Scroll Saw

Workbench Applications

• When mounting this saw to a workbench
a solid wood bench is preferred. A ply-
wood bench will cause noise and vibra-
tion to be more noticeable.
• Hardware to mount this saw to a work-
bench is not supplied with the saw.
However, we recommend the hardware
used be not smaller than the following.
Description
Hex Head Screw,
1/4-20 x length required ................. 4
Flat Washers, 1/4 I.D. ......................... 8
Lock Washers, 1/4 I.D......................... 4
Hex Nuts, 1/4-20................................. 8
• A soft foam pad to place between your
scroll saw and workbench is not sup-
plied with the saw. However, we highly
recommend the use of such a pad to
reduce noise and vibration.
Description
Soft foam pad such as carpet
padding, 24" x 12" x 1/2" .................. 1
Do NOT over tighten mounting bolts -
leave some cushion in the foam pad for
absorbing noise and vibration.
NOTE: Through normal use sawdust
accumulates under the unit. Frequently
clean sawdust from under the unit to pre-
vent the linkage from binding, which could
overload and damage the motor.
Scroll Saw Base
Hex Head Screw
Workbench
Qty.
Hex Head
Screw
Flat Washer
1/2" Foam Pad
(Optional)
Qty.
Workbench
Flat Washer
Lockwasher
18
Top View
Side View
Hex Nut
Jam Nut