Bosch GWX18V-13C Instrucciones De Funcionamiento Y Seguridad página 13

Kickback Control:
The electronics in the power tool detects situ-
ations where the wheel or accessory may be at
risk to bind. The electronics prevents further
rotation of the drive spindle by switching the
power tool off (it does not prevent kickback). To
resume operation, turn on/off switch to the off
position, then restart tool.
Constant Response Circuitry:
Helps maintain near constant RPMs between
no-load and load conditions.
Soft Start:
Helps reduce stress on the motor that occurs
from a high torque start. Helps bring accessory
smoothly up to speed.
Automatic Restart Protection:
Helps prevent accidental startups after power
has been interrupted, e.g. the tool was un-
plugged with the switch locked in the on posi-
tion. To resume operation, turn on/off switch to
the off position, then restart the tool. See the
chart under Fig. 1 and Fig. 2 to find out which
grinders are equipped with the Automatic Re-
start Protection.
Let the grinder accessory
come to a complete stop be-
fore setting the tool down. The brake action of
this grinder is not intended as a safety feature.
Using the appropriate guard when operating the
grinder is your best protection against uninten-
tional contact with a spinning accessory. Unin-
tended contact with a rotating accessory can
cause property damage and\or personal injury.
Know the charge state of
your battery. The electric
braking action is initiated ONLY by the release
of the trigger switch and in a tool that has pow-
er available. When electrical power is lost due
to a discharged battery or other causes, the
electric brake will not operate and the motor
will gradually slow down. Unexpected run down
time may cause property damage and/or per-
sonal injury.
160992A5K0 GWX18V-13CP 202206.indd 13
Functional Descriptions
Overload Protection:
Helps protect tool from excessive heat that may
damage motor. If tool stops or slows during op-
eration, allow motor to cool for 30 seconds by
running no-load. If the overload protection stops
the tool repeatedly, excessive force is causing
the tool to overload. Stop excessive force and
readjust work piece to reduce force applied.
Drop Control:
This grinder is equipped with sensors that de-
tect impact to the grinder. The grinder will turn
off if it is dropped on most hard surfaces from
height greater than one foot, or hit with force
approximately equivalent to more than a one
foot drop. After any impact or activation of the
shut off feature, always inspect the grinder and
the battery for signs of damage and do not use
the grinder or the battery if any damage is sus-
pected.
Brake Operation
Your grinder is equipped with an automatic elec-
tric brake which is designed to stop the acces-
sory from spinning in approximately two (2) sec-
onds after you release the trigger switch. This
feature helps improve jobsite productivity.
Braking starts once the power is turned off. The
brake requires a charged battery to function.
Stopping time will vary depending on, among
other factors, accessory used, and number of
actuations. The electric brake of your grinder
has been designed for a high degree of reliabil-
ity, but unexpected circumstances such as con-
tamination or failure of the motor's components
can cause the brake to not activate. If the tool
operates but the brake does not consistently
stop the accessory in about 2 seconds, DO NOT
use the grinder and have it serviced by a Bosch
Factory Service Center or Bosch authorized ser-
vice facility.
-13-
6/27/22 7:17 AM