GASPARDO PA1 Empleo Y Mantenimiento página 42

Ocultar thumbs Ver también para PA1:
Idiomas disponibles
  • ES

Idiomas disponibles

ENGLISH
During the assembly phase, rotate the dosing roller in the driving
direction and push it into the doser (Fig. 23), ...
... until the drive pin engages in the gearbox (Fig. 24). Do not
forget to fasten the agitator drive belt first, if it has been removed
or replaced!
To start up the agitator, first fit the belt on the small agitator disc,
then apply pressure to the lower edge of the dosing roller and, on
the opposite side, rotate the dosing roller on the handwheel, in
the driving direction until the belt comes off (Fg. 25).
4.1.4 FEELER PIN
The feeler unit may also be easily disassembled in a single
block in a matter of minutes for cleaning purposes. It consists of
5 single hatches that are spring-loaded to ensure tight closing.
The hatches do not touch the distribution wheel while it is in
operation! Thanks to the separators fixed between one hatch
and the next, it is possible to activate each element independently
of the others. Moreover, the separators are shaped in such as
way as to act as a shield against foreign bodies that could
damage the dosing roller. The hatches are adjustable and can
be lowered by up to 14 mm.
Always use gloves. The new parts especially might have sharp
edges that could injure the operator!
In order to disassemble the feeler unit, loosen the four nuts of
the axles (front and back) (Fig. 26), using a 13 mm spanner ...
42
WARNING
USE AND MAINTENANCE
fig. 23
fig. 24
fig. 25
fig. 26
g
cod. G19502170
loading