GASPARDO PA1 Empleo Y Mantenimiento página 39

4) The hydraulic pipes must be connected correctly to the tractor
distributors (see chapter 3.1) following the instructions on
each pipe (Fig. 11).
5) Raise the front machinery and remove the feet. In order to
guarantee the rotation of the transmission wheel, adjust the
working height of the machinery from the ground (45 – 55 cm
Fig. 12). This distance must remain constant during
operation.
ATTENTION
If this height is not observed, the transmission wheel could
lose its grip and the lower part of the machinery could be
damaged by clods, boulders and stubble, etc.
3.2.2 REAR EQUIPMENT
1) Assemble the fertiliser distributor with the flexible tubes and
with the central tubing at the centre of the precision planting
unit if possible.
2) Connect the flexible tubes from the distributor to the fertilisation
parts using the special hose-clips.
3) The machine in the correct operating position, check the
length of the seed descent pipes: while the seeder is
operating, it is important to avoid folds and bends in the pipes
which can lead to their breaking. Adapt them, if necessary, by
varying the length as shown in Figure 13.
3.2.3 CENTRAL CONNECTION
The manufacturer provides a 100 mm diameter rigid tube for
fitting to the tractor. Connect both ends of the rigid tube to the
machinery mounted back and front with the 100 mm diameter
flexible tube (Fig. 14). Avoid creases and folds that could lead to
breakage (Fig. 13).
cod. G19502170
USE AND MAINTENANCE
fig. 11
fig. 12
fig. 13
g
ENGLISH
fig. 14
39