Maintenance; Keep Machine Clean; Troubleshooting; Failure To Start - Delta 36-6013 Manual De Instrucciones

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or
servicing, before installing and removing accessories, before adjusting and when making repairs. An
accidental start-up can cause injury.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
For best performance use a shop vacuum or blower to keep saw blade area, the dust collection system, the guarding system and
rails free of saw dust and other debris.
MAINTENANCE REMINDERS
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE: Keep this area free of dust and debris buildup. Blow out area regularly with compressed air.
NOTE: If the riving knife clamp can't move freely, have the saw serviced by authorized Delta Power Equipment Corporation service
center personnel.
WORM GEARS: Keep the bevel gears free of dust and debris buildup. Blow out area regularly with compressed air. Use a lithium-
based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY: NOTE: Debris can also be removed from the saw from below
the throat plate, inside the dust port.
For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call Delta Power
Equipment Corporation Customer Care at 1-800-223-7278.

FAILURE TO START

If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle, and check
reset button on power switch housing. Also, check for blown fuses or open circuit breakers in your power line.

MAINTENANCE

TROUBLESHOOTING

36