Using The Miter Gauge - Delta 36-6013 Manual De Instrucciones

USING THE MITER GAUGE

There are two miter gauge grooves. One on either side of the blade, maximum 30°. When making a 90º cross cut, use either
groove. For beveled cross cut use the groove on right so that the blade is tilted away from miter gauge and hands.
Loosen the miter gauge lock knob. Rotate the gauge until desired angle on scale is reached. Re-tighten lock knob.
See Figure 31.
Using Rip Fence
To reduce the risk of injury, always make sure the rip fence is parallel to the blade before beginning any operation.
• Place rip fence on the white tabs.
• Push locking lever down slowly to automatically align and secure fence.
• Lock rear lever.
MAKING ADJUSTMENTS
LOCK
KNOB
FIGURE 31
FIGURE 32
30