Idiomas disponibles
Idiomas disponibles
LCD
Description
Display
The auto-parking icon
blinks on the LCD.
Brake pedal icon shows on
the LCD
Seat sensor icon shows on
the LCD
PTO Switch icon blinks
Energy regeneration icon
blinks occasionally.
CCS icon blinks
Notice: If a fault code appears on LCD screen, remove all battery packs and re-insert them a few minutes later. If this doesn't solve the prob-
lem, follow the fault code troubleshooting below.
Mower
Fault code
Status
on LCD
Indicator
n/a
OFF
n/a
OFF
n/a
OFF
n/a
OFF
n/a
OFF
n/a
OFF
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200S/ZT4200S-FC
Audio
Cause
Indicator
The mower is
parked on a slope
and the operator
Keeps
leaves the mower
beeping
without setting
the parking-brake
pedal at the brak-
ing position.
The parking-
brake pedal is
No
set at the braking
position.
The operator
leaves the seat
No
or the seat safety
interlock system
is disconnected.
The blade motor
was interrupted
in operation and
No
the PTO switch
is not set to off
position.
The kinetic
energy generated
during braking or
driving downhill
No
is converted into
electricity to
charge the bat-
tery packs.
The CCS (cruise
control system)
No
function has
failed.
Solution
Set the brake pedal at the braking
position. The auto-parking icon will
turn off and the sound indicator will
stop beeping.
Release it before starting the mower.
If with the operator is seated on the
seat and the icon is on, stop operating
the mower immediately and check the
seat connection. If the seat connection
with the mower is confirmed correct,
please contact a qualified service
technician for repairs.
Before restarting the mower, push the
PTO switch downward to disen-
gage the deck motor. Please see
"TROUBLESHOOTING" section in this
manual for reference.
This is normal operation. No action is
needed.
The CCS function could not be set
when the mower is driving at very low
speed or is driving in reverse.
73
