Volvo Penta IPS Dynamic Positioning System Instrucciones De Montaje página 6

Idiomas disponibles

Push the bolt (4) with washer (5) through the tripod (D)

and install the washer (6) and nut (7) from below. Fasten

the DPS antenna.

NOTE! Seal all bushings with marine sealant.

IMPORTANT! At the base of the DPS antenna there is an

arrow. This arrow must always point towards the bow (see

illustration).

10.

Tighten the union nut (A) on the cable bushing with a

23 mm open end wrench.

NOTE! Do not tighten the union nut too hard.

Refer to Connecting connectors before connecting the

DPS antenna to the EVC system.

Foldable, removable targa bar, antenna mast

If the DPS antenna is installed on a foldable installation,

the connection must be flexible. There must be sufficient

cable slack. Refer to illustration.

NOTE! Be careful to secure the cable with sufficient flexi-

bility (slack) to ensure correct function.