Disassembling Parts For Cleaning And Sterilisation - Mectron combi touch Manual De Uso Y Mantenimiento

DISASSEMBLING PARTS FOR CLEANING AND STERILISATION

At the end of the irrigation circuit "flush"
cycle, disassemble the individual parts
(see Chapter 7 on page 45
proceed to clean and sterilise them (see
Chapter 8 on page 49 ).
CAUTION: If the handpiece is stowed
back in its support, with the "flush"
function selected
(flashing LED) but not running, the
function is deactivated;
CAUTION: During the "flush" cycle,
i.e. when the function has been selected
and activated by pressing the pedal,
if the handpiece is stowed back in the
support, the cycle is not interrupted.
7 DISASSEMBLING PARTS FOR CLEANING
AND STERILISATION
Before carrying out the cleaning procedures described in
accessories and components of the combi touch .
WARNING: Switch the appliance off.
Always switch the appliance off using
the switch and disconnect the power
supply cable from the wall socket and
machine core unit before carrying out
cleaning and sterilisation tasks.
Disconnect the pedal from the appliance:
grasp the pedal connector, press the
release tab and pull the connector back;
CAUTION: Do not try to unscrew or
turn the connector during disconnection:
this might damage the connector.
CAUTION: While disconnecting the
cable from the pedal, keep always and
only the connector of the cord. Never
pull the cord itself.
6
) and
1
2
Chapter 8 on page 49 , disconnect all
OFF
45