After
rinsing
the
disassemble the individual parts (see
Chapter 7 on page 45
clean and sterilise them (see
page 49
).
CAUTION: If the handpiece is stowed
back in its support, with the "flush"
function selected
(flashing LED) but not running, the
function is deactivated;
CAUTION: During the "flush" cycle,
i.e. when the function has been selected
and activated by pressing the pedal,
if the handpiece is stowed back in the
support, the cycle is not interrupted.
6.2
POLISHING - Polisher Part
Lift the air-polishing handpiece or quick
coupling on the cord of the air-polishing
handpiece;
CAUTION: Make sure the scaler
handpiece is stowed in its housing,
otherwise the system will remain
inactive.
CAUTION: Make sure that both
powder containers are inserted in the
device before activating the "flush"
function.
Position the quick coupling on the cord
of the air-polishing handpiece, with or
without the air-polishing handpiece, over
a container or sink to catch the liquid and
powder that will be released during the
"flush" cycle;
irrigation
circuit,
) and proceed to
Chapter 8 on
FLUSH FUNCTION
10
1
2
43