Husqvarna 525LK Manual De Usuario página 7

1. Press the throttle trigger lockout (A) and make
sure that the throttle control is released (B). When
you release the handle the throttle control and
the throttle trigger lockout both move back to their
initial positions. This movement is controlled by
two independent return springs. This arrangement
means that the throttle control is automatically
locked at the idle setting.
B
2. Make sure that the throttle control is locked at
the idle setting when the throttle trigger lockout is
released.
3. Press the throttle trigger lockout and make sure that
it returns to its intial position when you release it.
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
5. Start the product (refer to the instructions under
start the product on page 14 ) and apply full throttle.
1027 - 003 - 09.06.2022
A
To
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
page 15 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Accessories on page 21 .
Refer to,
WARNING:
recommended cutting attachment guard for
the cutting attachment that you use. If an
incorrect or faulty cutting attachment guard
is fitted this can cause serious personal
injury. Refer to,
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It
Maintenance on
Do not use a cutting
Always use the
Technical data on page 20 .
7