Tabla de contenido
Idiomas disponibles
Idiomas disponibles
O R I G I N A L I N S T R U C T I O N
4.3 CURSOR
While the cursor will be fitted the correct way round when the tool is supplied, we recommend that you check its orientation
before fitting the nose equipment. The sprung loaded, slightly concave, end of the cursor should point towards the front of
the tool as shown in the illustration.
When fitted the correct way round, the cursor will easily slide out of the barrel when a mandrel is pushed into its centre then
pulled back.
To reverse the orientation of the cursor, follow these steps:
Item numbers in bold refer to the general assembly and parts list for
the 07537-00200 on pages 19-20.
•
Remove the clip 48 and slide off end cap 50.
•
Using an Allen Key, remove one cap head screw 5 ensuring that any
trapped air is exhausted. remove the second cap head screw 5.
Pull out rear plug 47.
•
Pull out tail jaw piston assembly 51 together with jaws 34.
•
Lift out spring 35 and jaw housing 41.
•
Insert a mandrel into the hole in the rear end of barrel 44 until it protrudes through the front of the barrel, then pull out
•
the mandrel and cursor together through the front.
•
Reassemble components in reverse order.
Insert Mechanical Cursor Assembly 36 into the front of the barrel, correct way round.
•
4.4 LOADING AND RELOADING THE TOOL
The procedure for loading the tool and for fitting the nose equipment to the tool is integral.
When ordering a complete tool or system you will normally be supplied with all the nose equipment required for the
fastener to be placed. To identify nose equipment components or to select the correct elements, read the nose equipment
section, in the accessories manual (07900-09508).
If you have been supplied with a nose jaw, mandrels and mandrel follower springs proceed with loading the tool and fitting
the nose equipment as shown overleaf.
Item numbers in bold refer to the general assembly and parts list for the 07537-00200 on pages 19-20.
If fitted incorrectly, the cursor will not allow feeding of the fasteners.
IMPORTANT
IMPORTANT
E N G L I S H
CURSOR
SPRING
LOADED END
NOSE
JAWS
TOOL
BARREL
11
Tabla de contenido
