Manufacturer's Warranty; Further Information; Originele Handleiding; Over Deze Documentatie - Hilti TE DRS-B Manual De Instrucciones

Trouble or fault
An excessive amount of dust
is generated.
TE DRS­B dust removal mod-
ule falls off
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
9

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10

Further information

For more information on operation,
qr.hilti.com/manual/?id=2494449
This link is also to be found at the end of the operating instructions, in the form of a QR code.

Originele handleiding

1 Informatie over documentatie
1.1

Over deze documentatie

• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
• De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
1.2 Verklaring van de tekens
1.2.1 Waarschuwingsaanwijzingen
Waarschuwingsaanwijzingen waarschuwen voor gevaren bij de omgang met het product. De volgende
signaalwoorden worden gebruikt:
10 Nederlands
Possible cause
Suction channel clogged.
Exposed accessory tool length
more than 125 mm.
Dust removal module not correctly
installed.
Adapter and tool holder are oily or
greasy.
Clamping mechanism damaged.
Wrong adapter selected.
technology, environment and recycling,
Action to be taken
▶ Clean the suction channel.
▶ Use a shorter accessory tool or
use the long suction head.
▶ Adapter must be pushed all the
way on to the tool holder and
into the suction base. See the
section headed "Installing dust
removal module" → page 8.
▶ Use a cloth to wipe oil and
grease off the adapter and the
outside surfaces of the tool
holder.
▶ Replace clamping mechanism
(toggle lever and clamping
band).
▶ Select the correct adapter.
follow this link:
249449
*249449*