Troubleshooting - cecotec BOLERO AGUAZERO 6000 Manual De Instrucciones

ENGLISH

9. TROUBLESHOOTING

Problem Possible causes
The dishwasher The fuse has blown or
does not turn on the circuit breaker has
tripped.
The power supply is
not on.
Water pressure is too
low.
The dishwasher door is
not properly closed.
The water in the Twisted or trapped
dishwasher drain hose.
is not drained
Blocked filter.
Blocked kitchen sink.
84
Possible solutions
Replace the fuse or restart the circuit
breaker.
Remove any other device sharing the
same circuit as the dishwasher.
Make sure the dishwasher is on and door
is properly closed.
Make sure that the power cord is plugged
into the socket properly.
Check the water supply is properly
connected and the tap is open.
Make sure you properly close the door
and it clicks.
Check the drain hose.
Check the filtering system.
Check the kitchen sink to make sure it
is draining correctly. If the problem is
the kitchen sink is not draining, you may
need a plumber instead of the Technical
Service.
Foam in the Unsuitable detergent.
interior
Spilled rinse aid.
The interior is You may have used
stained detergent with
colouring.
White film on the Hard water.
interior surface
There are rust The damaged articles
stains on the are not rust-resistant.
cutlery
You did not run a
programme after
adding salt to the
dishwasher. There
were salt remains in
the washing cycle.
The water softener
cover is loose.
ENGLISH
Use only detergent special for
dishwashers to prevent foam formation.
If there is foam forming, open the
dishwasher and let it evaporate. Add a
litre of cold water in the bottom of the
dishwasher.
Close the dishwasher door and select
any cycle. At the start, the dishwasher
will drain the water. Open the door after
the drainage to check the foam has
disappeared.
Repeat the process if necessary.
Always clean spilled rinse aid
immediately.
Make sure your detergent does not
contain colouring.
To clean the interior, use a soft and damp
cloth with detergent for dishwasher and
use rubber gloves. Never use any cleaner
other than dishwasher detergent, as this
may cause foaming.
Avoid washing articles which are not
rust-resistant in the dishwasher.
Always run a wash programme with
no load after adding salt. Do not select
the Turbo function (if it is included in
this model) after adding salt to the
dishwasher.
Check the water softener cover is
properly closed.
85
AGUAZERO 6000/SILVER