Creating The Opening (If Necessary) - Dometic COOLAIR RTX 1000 Instrucciones De Montaje

CoolAir
• If a roof cutout is required (e.g. if there is no existing roof hatch opening or the
roof hatch opening is not suitable and cannot be used), it is mandatory to
check with the manufacturer of your vehicle whether this is permissible and
what must be observed to ensure that the vehicle's registration does not
expire.
• The downward slope of the roof in forward direction in the area where the
unit is installed must not be more than:
– RTX1000: 8°
– RTX2000: 20°
• The assembly parts supplied must not be modified during installation.
• The ventilation openings must not be covered over (minimum distance from
other external attachments: 100 mm).
• Follow the vehicle manufacturer's guidelines when installing the system and
establishing the electrical connections.
I
NOTE
After installation of the system, the pre-set parameters on the system software
must be checked (chapter "Configuring the system software" on page 13).
7.2

Creating the opening (if necessary)

I
NOTE
To simplify the task of creating the opening, there is a template integrated in
the packaging of the installation kit.
➤ Create an opening measuring 500 mm x 400 mm with rounded corners with
a radius of R25 (fig. 6 and fig. 7, arrow = forward direction).
I
NOTE
Dispose of all waste materials separately. When doing so, follow the waste
disposal requirements applicable in your local area.
EN
Installation
9