FONESTAR ZS-2000M Manual De Instrucciones página 26

EN
INQUIRING THE DEVICE ID
- Press the buttons in order (not release): "Fn" and "CLOSE" one by one, then follow the reverse order to
release button. Please release "CLOSE" button first, then releas "Fn".
- If you hear the device sounded "beep......", setting successfully.
- The speaker inside the ZS-2000M will play the ID voice.
RESTORE ZS-2000M TO DEFAULT IP
- Press the buttons in order (not release): "Fn", "MONITOR", and "RESET" one by one, then follow the
reverse order to release button. Please release "RESET" first, then release "MONITOR", finally release
"Fn".
- If you hear the device sounded "beep......", setting successfully.
- Restart the device power, and the default IP address (The default IP is 192.168.2.200).
IMPEDANCE CALIBRATION
If the system need supervise the speaker circuits, after installation, please calibrate the speaker circuit
impedance.
- Press the buttons in order (not release): "Fn", "MONITOR", and "FAULT" one by one, then follow the
reverse order to release button. Please release "FAULT" first, then release "MONITOR", finally release
"Fn".
- If you hear the device sounded "Beep......", setting successfully.
- 26 -