FONESTAR ZS-2000M Manual De Instrucciones página 19

CONNECTING THE POWER SUPPLY CABLES
The power supply cables for the main system components include the following items:
- ZS-2000M or ZS-4328IO Main and Standby Power Supply Cables
- ZS-1500/ZS-2250/ZS-4125 Main and Standby Power Supply Cables
- ZS-200M Power Supply Cable
ZS-2000M or ZS-4328IO Main and Standby Power Supply Cables
CONNECTING THE MAIN POWER SUPPLY CABLE
1. Strip off the wire jacket of one end of the AC power supply cable by 20mm and connect the cable to
the main power supply wiring terminal, as shown in Figure 30.
Figure 30 Schematic Diagram of the ZS-2000M or the ZS-4328IO Main Power Supply Cable Connection
Note: The wires are identified as L (Live wire), N (Null wire), and E (Earth wire).
2. Tighten the screws to prevent the power supply cable from coming loose, and cover the power supply
interface set.
3. Insert the wiring terminal of the installed power supply cable into the main power supply input port of
the ZS-2000M or the ZS-4328IO, and tighten the screws at both ends.
4. Insert the other end of the power supply cable into the main power supply equipment.
CONNECTING THE STANDBY POWER SUPPLY CABLE
Connect one end of the prepared standby power supply cable to the ZS-2000M or the ZS-4328IO standby
power supply input port, and the other end of the cable to the emergency power supply (such as the fire alarm
system power supply). The power supply cable must support DC 24V. Pay special attention to the
connections of the positive and negative poles of the power supply. Refer to Figure 31 and Figure 32.
- 19 -
EN