FONESTAR ZS-2000M Manual De Instrucciones página 21

ZS-1500/ ZS-2250/ ZS-4125 MAIN AND STANDBY POWER SUPPLY CABLES
CONNECTING THE MAIN POWER SUPPLY CABLE
Insert one end of the power supply cable into the ZS-1500/ ZS-2250/ ZS-4125 power supply input port,,
and connect the other end of the cable to the power supply equipment, as shown in Figure 33.
Figure 33 Schematic Diagram of the ZS-1500/ ZS-2250/ ZS-4125 Main Power Supply Cable Connection
CONNECTING THE STANDBY POWER SUPPLY CABLE
1. Strip off the wire jacket of one end of the prepared standby power supply cable by 20mm and connect
the cable to the standby power supply wiring terminal, as shown in Figure 34
2. Tighten the screws to prevent the power supply cale from coming loose, and cover the power supply
interface set.
3. Insert the wiring terminal of the installed power supply cable into the standby power supply input port
of the ZS-1500/ ZS-2250/ ZS-4125, and tighten the screws at both ends.
4. Insert the other end of the standby power supply cable into the standby power supply equipment, such
as the Uninterrupted Power Supply (UPS).
5. The power supply cable must support DC 24V. Pay special attention to the connections of the
positive and negative poles of the power supply.
- 21 -
EN