FONESTAR ZS-2000M Manual De Instrucciones página 13

f. Insert the power amplifier input wiring terminal of the installed audio output cable into the ZS-2000M
PA audio input port, as shown in Figure 19.
Figure 19 Schematic Diagram of the Audio Input Wiring Terminal Installation
g. Cover the power amplifier terminal with the protective terminal cover and tighten the screws, as shown
in Figure 20. This same operation applies to the ZS-2000M terminal and related protective cover.
Figure 20 Schematic Diagram of the Protective Audio Input Terminal Cover
Connecting the Dry Contacts (Optional)
This section describes connecting the external equipment or switch through the dry contacts.
ZS-2000M Dry Contact Input Preparation
1. Connect the dry contact cable to the dry contact input terminal.
Strip the wire jacket off one end of the prepared dry contact connection cable by about 10mm, insert
the wires into the dry contact wiring terminal (8P green euroblock connector of 3.81mm), and tighten
the screws. Refer to Figure 17 for more information.
2. Insert the dry contact input wiring terminal of the installed input cable into the ZS-2000M dry contact
port.
3. Connect the external dry contact equipment or switch to the other end of the dry contact input cable,
as shown in Figure 21.
- 13 -
EN