FONESTAR ZS-2000M Manual De Instrucciones página 10

EN
Figure 12 Schematic Diagram of Installing the ZS-2000M in the Cabinet
4. Install brackets on the left and right sides of the ZS-1500/ZS-2250/ZS-4125, as shown in Figure 11.
5. Install the ZS-1500/ZS-2250/ZS-4125 appliance into the cabinet, and tighten the screws to secure the unit,
as shown in Figure 12.
Note: 1U (1U=44.45mm) of space is required right above the ZS-1500/ZS-2250/ZS-4125 to allow for
proper appliance ventilation.
It is recommended to use an empty panel to close and open the installation space of the cabinet.
CONNECTING THE PROTECTIVE GROUNDING APPLIANCE WIRES
The ZS-2000M and ZS-1500/ZS-2250/ZS-4125 grounding terminals must be connected to the terminal
blocks through flexible cables with a cross-section of 1.5mm2 within the cabinet, as shown in Figure 9.
Note: Do not connect the grounding output cable with the grounding input cable as a short circuit can
occur.
CONNECTING THE SYSTEM COMPONENTS
This section describes the connections between the following system components:
- Connecting the Sound Source Equipment to the ZS-2000M or ZS-4328IO
- Connecting the ZS-2000M to the ZS-1500/ZS-2250/ZS-4125
- Connecting the ZS-2000M and ZS-4328IO to the ZS-200M
- Connecting the Dry Contacts (Optional)
- Connecting the Noise Detector (Optional)
- 10 -