FONESTAR ZS-2000M Manual De Instrucciones página 16

EN
Connecting the Noise Detector (Optional)
If detecting the environmental noise is required, the noise detector can be connected through the AVC port.
1. Insert the prepared AVC connection cable into the AVC input wiring terminal and tighten the screws.
2. Insert the AVC wiring terminal of the installed cable into the ZS-2000M AVC port.
3. Install the noise detector on the other end of the AVC cable, as shown in Figure 25.
Connecting the Loudspeakers
The ZS-2000M can be directly connected to loudspeakers. The following steps describe this process:
1. Strip off the wire jacket of one end of the prepared audio cable by about 10mm, insert the loudspeaker
wiring terminal, and tighten the screws.
2. Insert the loudspeaker wiring terminal of the installed audio cable into the MCU loudspeaker port.
3. Connect the loudspeaker to the other end of the audio cable, as shown in Figure 26.
Figure 26 Schematic Diagram of the Loudspeaker and Audio Cable Connection
Connecting the ZS-2000M and ZS-4328IO to the ZS-200M
The ZS-2000M and ZS-4328IO can be connected to the ZS-200M in the following two ways:
- Directly connecting the ZS-2000M and ZS-4328IO to the ZS-200M
- Connecting the ZS-2000M and ZS-4328IO to the ZS-200M through a network switch
DIRECTLY CONNECTING THE ZS-2000M AND ZS-4328IO TO THE ZS-200M
Connect the ZS-2000M and ZS-4328IO to the ZS-200M using 2 twisted-pair cables. The following
describes this process:
Figure 25 Schematic Diagram of the Noise Detector Connection
- 16 -